Botumo bo phahameng ba Rs485 Ho Ethernet - E entsoe ka sebopeho sa E1-FE+8RS232 Converter JHA-CE1F1R8 - JHA

Sefetoleli se entsoeng ka sebopeho sa E1-FE+8RS232 JHA-CE1F1R8

Kakaretso

Sefetoleli sena sa protocol (interface converter) se sebelisa moralo o moholo oa FPGA, se fana ka sebopeho sa E1 se hlophisitsoeng le sehokelo sa Ethernet le 8channel RS232/422/485, hoa khoneha ho fihlela data ea 10 / 100Base-T Ethernet ka phetiso ea liteishene tsa E1, ke mokhoa o phahameng haholo. tshebetso, ho ithuta ka borokho Ethernet borokho. Sesebelisoa se sebetsa e le katoloso ea lisebelisoa tsa Ethernet, ts'ebeliso ea marang-rang a teng (PDH / SDH / microwave, joalo-joalo) e fanoeng ke likanale tsa E1 ho hokahanya lipheletsong tse peli tsa theko e tlase ea Ethernet le likhokahano tsa serial. Bokhoni ba lisebelisoa tsa tlhahlobo ea loop ho thusa ho bula le ho lokisa mesebetsi e tloaelehileng.

Setšoantšo sa Sehlahisoa

Mofuta oa 19inch 1U

Likaroloana

• E ipapisitse le IC ea boinotšing
• E khona ho hlokomela ho lekola le ho laola lisebelisoa tse hole, data ea tsamaiso ea OAM ha ea ka ea nka nako ea mosebelisi mme ea boloka bandwidth ea E1
• E1 e tšehetsa nako efe kapa efe e behiloeng, sekhahla ke 64K-2048K
• Sesebelisoa sa lehae se ka qobella sekhahla sa sesebelisoa se hole se se latele
• E-ba le sesupo ha sesebelisoa se hole se tima kapa mohala oa E1 o robehile kapa o lahleheloa ke lets'oao;
• Eba le ts'ebetso ea E1 interface loop back check, qoba converter e soahlamane ka lebaka la ho khutla ha loop interface;
• Sebopeho sa Ethernet se tšehetsa liforeimi tsa jumbo (2036 Bytes);
• Inter-set dynamic Ethernet MAC address (4,096) e nang le ts'ebetso ea ho sefa ea data ea lehae
• Khokahano ea Ethernet e ts'ehetsa 10M/100M, halofo / e felletseng ea duplex auto- Negotination, tšehetso ea VLAN
• Sehokelo sa Ethernet se ts'ehetsa AUTO-MDIX (mohala o tšetsoeng le mohala o hokahaneng ka kotloloho o ikamahanyang le maemo);
• Eba le ts'ebetso ea ho iketsetsa bocha ea Ethernet, lisebelisoa li ke ke tsa shoa
• Fana ka mefuta e 2 ea oache: oache e kholo ea E1 le oache ea mola oa E1;
• Fana ka 2 impedances: 75 Ohm ho se leka-lekane le 120 Ohm ho leka-lekana;
• Tšehetsa SNMP Network Management
• Serial Data Interface e ka ba RS232/RS422/RS485/TTL ka boikhethelo
• Seteishene sa serial se ka fetisetsa data ea serial e feto-fetohang ka mokhoa o tšoanang 300 Kbps-19200Kbps sekhahla sa baud
• Serial data multiplexing ka E1 tshehetsa ITU-T R.111 jumping coding mode
• Lintlha tsa serial tsa RS232 tsa lehae li ka laela RS232 serial data loop-back to local. Loop-back ka har'a selikalikoe sa kantle sa RS232 data interface, o ka leka chip ea RS232 ntle le tšenyo.
• Serial port interface lehalima-ts'ireletso e fihlile IEC61000-4-5 (8/20μS) DM(Mokhoa o fapaneng): 6KV, Impedance (2 Ohm), CM(Mokhoa o Tloaelehileng): 6KV, Impedance (2 Ohm) maemo a tloaelehileng

Mekhahlelo

♦E1 Interface

Interface Standard: lumellana le protocol G.703;
Interface Rate: n * 64Kbps ± 50ppm;
Khoutu ea Sehokelo: HDB3;

Tšitiso ea E1: 75Ω (ho se leka-lekane), 120Ω (ho leka-lekana);

Jitter tolerance: Ho latela protocol G.742 le G.823

Tlhokomelo e lumelletsoeng: 0 ~ 6dBm

♦Khokahano ea Ethernet (10/100M)

Sekhahla sa khokahano: 10/100 Mbps, halofo / e felletseng ea duplex ea lipuisano

Interface Standard: E lumellana le IEEE 802.3, IEEE 802.1Q (VLAN)

Bokhoni ba Aterese ea MAC: 4096

Sehokelo: RJ45, tšehetsa Auto-MDIX

♦Sebui sa serial

Standard

EIA/TIA-232 RS-232 (ITU-T V.28)

EIA/TIA-422 RS-422 (ITU-T V.11)

EIA/TIA-485 RS-485 (ISO/IEC8284)

Sebui sa serial

RS-422:TXD+, TXD-, RXD+, RXD-, Signal Ground

RS-485 4 lithapo: TXD+, TXD-, RXD+, RXD-, Signal Ground

RS-485 2 lithapo: Data+(Correspond TX+), Data-（Ikopanye le TX-）, LetshwaoFatše

RS-232: RXD, TXD, Signal Ground

♦Tikoloho ya mosebetsi

Mocheso o sebetsang: -10°C ~ 50°C

Mongobo o sebetsang: 5% ~ 95% (ha ho condensation)

Mocheso oa polokelo: -40°C ~ 80°C

Mongobo oa polokelo: 5% ~ 95% (ha ho condensation)

Litlhaloso

Kopo